Last year a welder working at a fabrication yard in Sharjah had a spark land on the sleeve of his coverall. The coverall was made of cotton, untreated, and had been purchased in bulk from a general uniform supplier since it was cheaper and appeared to be the same as the fire-retardant version that his […]
Fire Retardant Coverall vs Regular Coverall: What’s the Real Difference Read More »
In a single phone call a procurement manager at a mid-sized refinery recently asked us the same question in three different forms: Which fabric offers better protection? Which endures daily use? And which won’t exceed the budget when placing an order for 500 units. The question of whether to choose a modacrylic IFR coverall or
Modacrylic vs Aramid IFR Coverall: Fabric Comparison for Refinery Buyers Read More »
A welder welding overhead on a pipe rack has to cover his legs, whereas a welder sitting at a bench and using a TIG torch on thin sheet metal only needs sleeves that go past the elbow. If you buy the wrong type of clothing for either job, you will either spend too much on
Welding Suit vs Welding Jacket: Which Protection Do You Actually Need Read More »
A procurement officer working for one of the contractors at Ras Laffan once sent us a sample of coveralls and included the following question: does it really meet the required specifications or does it merely have ‘Nomex’ printed on the label? That question is at the heart of every Nomex coverall purchase order in Qatar.
Nomex Coverall for Qatar Gas Plants: Specification Checklist Read More »
One procurement manager, while organizing a turnaround team for an Al-Ahmadi site, described a time when a consignment of 300 coveralls failed a gate inspection. The garments appeared satisfactory since the color was correct, the size was appropriate, and the material felt heavy enough to be flame resistant. In fact, it wasn’t. The supplier had
Coverall Suppliers for Kuwait Oil and Gas Contractors Read More »
An electrician who was responsible for maintenance at a refinery on the Gulf Coast once said to a safety auditor that his team kept two suits in the locker: everybody took the 40-cal suit by default, while no one wanted to wear the 100-cal suit since it made what should have been a ten-minute panel
Arc Flash Suit 40 Cal vs Higher Cal Ratings: Choosing the Right HRC Level Read More »
A maintenance supervisor at a refinery in Jubail once said that his team used eleven sets of FR cotton coveralls over a period of fourteen months. The reason was not that the material caught fire but that the flame resistance gradually ceased to function after a large number of washings, and nobody realized it until
Nomex Coverall: When You Need It Over Standard FR Cotton Read More »
A procurement manager in Doha had once told a supplier to accept the “flame resistant” statement as true. However, three months later, customs prevented the shipment from being released since the certificate on record did not match the actual fabric present in the boxes. That one discrepancy in the documentation resulted in a delay in
IFR Coverall Manufacturers in India: What to Check Before You Order Read More »
A procurement manager working at a mid-size fabrication plant once put to us a straightforward question: the purchase order she had issued stated “boiler suit,” her site supervisor always referred to the same item as a “coverall,” and the vendor’s quote used both terms for the same line item. No one was incorrect, but no
Boiler Suit vs Coverall: Which One Does Your Industry Need Read More »
A worker at a substation is given a suit rated at 12 cal/cm². The panel that he is going to open has an incident energy of 27 cal/cm², and the figure had not been verified against the label before the work began. It is actually the gap, not the arc, that leads to most arc
Arc Flash Suit Buying Guide: NFPA 70E, IEC 61482, and Cal Ratings Explained Read More »
